山東通風管道已經廣泛應用于各行各業中，但是隨著使用時間的不斷增長，山東通風管道中會積累大量的雜質。如果這些雜質將長期儲存在管道中不清理的話，會在運行過程中加速其油的冷凝。如果溫度轉換過高，氣壓閥、液壓等部件會損壞，嚴重影響正常運行。因此，定期清理通風管道設備是非常必要的。但是應該如何清理呢?今天高氏通風管道有限公司的小編將告訴您應該如何清理。
Shandong ventilation pipeline has been widely used in all walks of life, but with the continuous growth of the use of time, Shandong ventilation pipeline will accumulate a large number of impurities. If these impurities will be stored in the pipeline for a long time without cleaning, it will accelerate the condensation of oil during operation. If the temperature conversion is too high, the air pressure valve, hydraulic and other components will be damaged, seriously affecting the normal operation. Therefore, it is necessary to clean the ventilation duct equipment regularly. But how to clean it? Today, the editor of Gao's Ventilation Pipe Co., Ltd. will tell you how to clean it.
山東通風管道安裝
Shandong ventilation pipeline installation
1.風管與風機連接時，進風口和出風口應安裝軟接頭。軟接頭的橫截面尺寸應與風機入口和出口的橫截面尺寸相同。軟管連接器可以由帆布、人造革和其他材料制成。軟管的長度不應小于200，且緊密度應適當。軟管可以緩沖風扇的振動。
1. When the air duct is connected with the fan, the air inlet and outlet should be installed with soft joints. The cross-sectional dimension of the flexible joint shall be the same as that of the fan inlet and outlet. Hose connectors can be made of canvas, synthetic leather and other materials. The length of the hose should not be less than 200 and the tightness should be appropriate. The hose can cushion the vibration of the fan.
2.輸送冷凝水或含水量較大的氣體時，水平管道應有坡度，并在低點與排水管連接。安裝時，風管底部不應出現縱向接縫，底部接縫處應暫停密封處理。
2. When transporting condensate water or gas with large water content, the horizontal pipeline should have slope and be connected with drainage pipe at low point. During installation, the longitudinal joint should not appear at the bottom of the air duct, and the sealing treatment should be suspended at the bottom joint.
3.輸送易燃易爆氣體的鋼板風管，應在風管的連接法蘭處安裝跳線，并與靜電接地網連接。
3. For steel plate air duct conveying inflammable and explosive gas, jumper shall be installed at the connecting flange of air duct and connected with electrostatic grounding grid.
4.風管與除塵設備和加熱設備連接時，設備安裝完畢后，根據理論測繪圖暫停預制安裝。
4. When the air duct is connected with the dust removal equipment and heating equipment, the prefabrication and installation shall be suspended according to the theoretical mapping map after the equipment is installed.
5.在山東，安裝通風管時，預制風管時應打開進出口。如果風管需要在安裝結束時打開，其接口應緊密。
5. In Shandong Province, when installing the ventilation pipe, the inlet and outlet should be opened when prefabricating the air duct. If the duct needs to be opened at the end of installation, its interface should be tight.
6.當水平風道高度超過4m時，安裝人員應佩戴安 全帶。腳手架或移動支架上的跳板應固定好，跳板的寬度應符合安 全規范。腳手架上的設備人員應攜帶袋子，以免掉落物體或電鉆傷人。
6. When the height of horizontal air duct exceeds 4m, the installation personnel shall wear safety belt. The springboard on the scaffold or mobile support shall be fixed, and the width of the gangway shall comply with the safety regulations. Equipment personnel on the scaffold should carry bags to avoid falling objects or electric drill from hurting people.
山東通風管道廠家
Shandong ventilation pipe manufacturer
以上就是我們
山東通風管道廠家向您介紹的關于清理通風管道雜質的方法，通風管道應該每三個月清洗一次，這樣不但能保證平時的正常運行，還能延長通風管道的使用壽命。大家一定要認真對待我們的設備，感謝大家的關注。
The above is our Shandong ventilation duct manufacturers introduced to you about the method of cleaning the air duct impurities, the ventilation duct should be cleaned every three months, so as not only to ensure the normal operation, but also to extend the service life of the ventilation duct. We must take our equipment seriously. Thank you for your attention.
上一篇：濟南通風管道中的雜物該如何進行清理？
下一篇：濟南通風管道的類型及通風管道的具體作用介紹
